#
To fold the seat back into the driving posi‐
tion: press and hold the release button 1
until the seat engages audibly.
The seat tilts downwards and stops in the
front position. The seat backrest remains in
the cargo position.
#
To interrupt the folding procedure before
engagement, let go of release button 1. To
continue the folding procedure, press and
hold the release button again.
#
Set the backrest angle and seat fore-and-aft
adjustment using the buttons on the door.
%
To increase the size of the cargo compart‐
ment, you can move the rear seat backrests
into the cargo compartment floor position
(/ page 117).
Folding the rear seats forwards mechanically
(emergency release)
The release loops are located on the outer sides
and rear sides of the seats in the second row of
seats.
Side release loops
Release loops on the rear sides
#
Pull one of release loops 1.
#
Fold the seat backrest forwards.
#
Before starting the journey, make sure that
the seat backrest and the rear bench seat
are engaged.
Head restraints
Adjusting the front seat head restraints
mechanically
&
WARNING Risk of injury from adjusting
the vehicle settings while the vehicle is in
motion
You could lose control of the vehicle in the
following situations:
R
if you adjust the driver's seat, the head
restraint, the steering wheel or the mirror
while the vehicle is in motion
R
if you fasten your seat belt while the vehi‐
cle is in motion
#
Before starting the engine: adjust the
driver's seat, the head restraint, the
Seats and stowing
103
To Next Page
Loading...
Need help?
General
