121
Controls in detail
Lighting
Switching on high beams
왘 Turn the exterior lamp switch to B
or to U (
컄 page 117).
왘 Push the combination switch in
direction 1.
The high beam indicator A in the ta-
chometer comes on.
High beam flasher
왘 Pull the combination switch briefly in
direction 2.
Hazard warning flasher
The hazard warning flasher can be activat-
ed with the ignition switched on or off. It is
activated automatically when an airbag is
deployed.
The switch is located above and between
the center air vents.
1 Hazard warning flasher switch
Switching on the hazard warning
flasher
왘 Press hazard warning flasher
switch 1.
All turn signals flash.
Switching off the hazard warning
flasher
왘 Press hazard warning flasher switch 1
again.
i
With the hazard warning flasher acti-
vated and the combination switch set
for either left or right turn, only the re-
spective left or right turn signals will
operate when the starter switch is in
position 1 or 2.
To Next Page
Loading...
Need help?
General
