3. Always observe the five golden rules of electrical installation!
Now, no charging procedure can be carried out with the smart Wallbox Home and it can be uninstalled by
a qualified specialist electrical contractor if required. If you do not want to uninstall the Wallbox, replace
the housing cover by hooking it onto the upper edge of the housing base and lock it using the key provi-
ded.
To take the Wallbox back into operation at a later time, please proceed as follows:
1. Remove the housing cover of the Wallbox, open the access flap in the electronic components cover and
flick the pivot lever of the RCCB into the I position.
2. Close the access flap. Hook the housing cover onto the upper edge of the housing base and lock it
using the housing cover key provided.
3. Switch on the upstream MCB.
When the smart Wallbox Home is reconnected to the electricity grid, it will initiate the start-up proce-
dure: As described in section
„Taking the Wallbox into operation.“ on page 15, the vehicle can now be
connected for charging.
Returning your Wallbox.
Should your Wallbox display error messages permanently during installation or subsequent operation, or
if it does not function properly, contact your local smart technical support. If the error can still not be re-
solved, the Wallbox must be replaced. For this purpose, you must take the Wallbox out of operation, have a
qualified specialist electrical contractor uninstall it and return it via smart technical support for repairs.
In addition to the Wallbox itself, you must fill in and include the 'Checklist for returns' document with
the parcel. Please ensure that the data entered in the document are correct and complete, and that the
document has been signed by the customer as well as the installing technician. Otherwise the Wallbox
cannot be replaced.
You can find the 'Checklist for returns' document on the www.yourwallbox.de website via this link:
www.yourwallbox.de/downloads/documents/RMA_document_Home_Advanced.pdf
To Next Page
Loading...
Need help?
General
