• Screw the threaded tip of the Ovitrelle pre-filled pen into the
outer needle cap until you feel a light resistance.
Warning: Do not attach the needle too tightly; the needle could
be difficult to remove after the injection.
• Remove the outer needle cap by pulling it gently.
Put it aside for later use.
• Hold the Ovitrelle pre-filled pen with the needle pointing
upward.
• Carefully remove and discard the green inner shield.
3.4. Look closely at the tip of the needle for tiny drop(s) of fluid
• If you see a tiny drop(s) of fluid proceed to Section 4:
Setting the dose to 250.
CAUTION:
If you do not see a tiny drop(s) at or near the needle tip, you must perform the steps on the next page.
To Next Page
Loading...