5.4 Inject the dose as you were trained to do by your doctor or nurse
• Slowly push the needle into the skin entirely (1).
• Press the dose knob down as far as it will go and hold it to
complete the full injection.
• Hold the dose knob down for a minimum of 5 seconds to ensure
you inject the full dose (2).
• The dose number shown in the dose display will turn back
to ‘0’. This shows that the complete dose was delivered.
• After a minimum of 5 seconds, pull the needle out of the skin
while keeping the dose setting knob pressed down (3).
• Release the dose setting knob.
6. After the injection
6.1 Check that the dose display shows ‘0’
• This confirms that the dose has been fully delivered. Do not attempt to inject a second time.
• In case the dose display doesn’t show 0, please contact your doctor or pharmacist.
To Next Page
Loading...