To Next PageTo Next Page
Need help?Do you have a question about the Mercury 140 and is the answer not in the manual?
General| Horsepower | 140 hp |
|---|---|
| Cylinders | 4 |
| Fuel Induction System | Electronic Fuel Injection (EFI) |
| Steering | Hydraulic |
| Shaft Length | 20 in / 25 in |
| Full Throttle RPM | 5000 - 6000 RPM |
Details how to transfer the limited warranty to a subsequent purchaser.
Explains the process of registering the product for warranty coverage.
Outlines the specific components and conditions covered by the warranty.
Lists items and conditions explicitly excluded from warranty coverage.
Outlines the specific components and conditions covered by the warranty.
Lists items and conditions explicitly excluded from warranty coverage.
Details coverage for product failure directly caused by corrosion.
Lists specific exclusions from the corrosion warranty.
Outlines the operator's duties for safe boat and outboard operation.
Advises caution and slowing down when people are in the water.
Advises caution in shallow water and warns about potential damage from submerged objects.
Explains the function and importance of the lanyard stop switch for safety.
Details the proper installation procedure for the outboard motor.
Provides instructions and precautions for trailering a boat with the outboard.
Advises on the type of gasoline to use, including octane rating and alcohol content.
Recommends specific types of 2-cycle oil for the engine.
Details warning horn signals and functions for EFI models.
Explains the warning horn signals and their causes for carburetor models.
Explains the engine protection system that monitors sensors and reduces power.
Lists essential checks to perform before starting the engine.
Outlines the general procedure for starting the engine.
Continues the engine starting procedure, including checks and specific notes.
Provides instructions for breaking in a new engine.
Details how to flush the cooling system with fresh water after use.
Details the procedure for replacing the outboard propeller.
Explains how to inspect and replace spark plugs for optimal performance.
Lists recommended maintenance tasks and their frequency.
Explains how to check, drain, and refill gear case lubricant.
Continues the gear case lubrication procedure, including refilling and checking.
Outlines steps to protect the outboard during storage from rust and freezing.
Lists possible causes for the starter motor not cranking the engine.
