EasyManuals Logo

Mercury 2004 Monterey User Manual

Mercury 2004 Monterey
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
9. M+S or M/S: Mud and Snow. or
AT: All Terrain. or
AS: All Season.
10. Tire Ply Composition and Material Used: Indicates the number of
plies or the number of layers of rubber-coated fabric in the tire tread and
sidewall. Tire manufacturers also must indicate the ply materials in the
tire and the sidewall, which include steel, nylon, polyester, and others.
11. Maximum Load: Indicates the maximum load in kilograms and
pounds that can be carried by the tire. Refer to the tire label or the
safety certification label, located on the B-Pillar or the drivers door, for
the correct tire pressure for your vehicle
12. Treadwear, Traction and Temperature Grades
Treadwear: The treadwear grade is a comparative rating based on the
wear rate of the tire when tested under controlled conditions on a
specified government test course. For example, a tire graded 150
would wear one and one-half (1
1
2
) times as well on the government
course as a tire graded 100.
Traction: The traction grades, from highest to lowest are AA, A, B,
and C. The grades represent the tires ability to stop on wet pavement
as measured under controlled conditions on specified government test
surfaces of asphalt and concrete. A tire marked C may have poor
traction performance.
Temperature: The temperature grades are A (the highest), B and C,
representing the tires resistance to the generation of heat and its
ability to dissipate heat when tested under controlled conditions on a
specified indoor laboratory test wheel.
13. Maximum Permissible Inflation Pressure: Tire manufactures
maximum permissible pressure and/or the pressure at which the
maximum load can be carried by the tire. This pressure is normally
higher than the manufacturers recommended cold inflation pressure
which can be found on either the tire label or certification label which is
located on the structure by the trailing edge of the drivers door or the
edge of the drivers door. The cold inflation pressure should never be set
lower than the recommended pressure on the vehicle label.
The tire suppliers may have additional markings, notes or warnings such
as standard load, radial tubeless, etc.
2004 Monterey (mty)
Owners Guide (post-2002-fmt)
USA English (fus)
Maintenance and Specifications
254

Other manuals for Mercury 2004 Monterey

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 2004 Monterey and is the answer not in the manual?

Mercury 2004 Monterey Specifications

General IconGeneral
BrandMercury
Model2004 Monterey
CategoryAutomobile
LanguageEnglish

Related product manuals