1. Turn the ignition to the 4 (ON) position, then press the power door
unlock control 3 times.
2. Turn the ignition to the 3 (OFF) position, then press the power door
unlock control 3 times.
3. Turn the ignition to 4 (ON) position. Completing the sequence within
30 seconds enters a program mode and is confirmed by a horn chirp.
Activating or deactivating perimeter lighting once in program mode is
accomplished by:
• Pressing the power door unlock control twice within five seconds. At
this point, perimeter lighting will be activated if it was previously
deactivated, and deactivated if it was previously activated.
Confirmation of perimeter lighting being activated is provided by a
short horn chirp followed by a long horn sound; Confirmation of
perimeter lighting being deactivated is provided by a short horn chirp
only.
• Exiting the program mode is accomplished by turning the ignition to
any position other than the 4 (ON) position, or two minutes elapsing
since the program mode was entered.
Note: The puddle lamps cannot be deactivated. Performing this
deactivation procedure will only deactivate the head, park and tail lamps.
Autolock
This feature automatically locks all vehicle doors when:
• all doors are closed,
• the ignition is in the 4 (ON) position,
• the brake is pressed before reaching 5 km/h (3 mph), and
• the vehicle is traveling more than 5 km/h (3 mph).
Relock
The autolock feature repeats when:
• an “autolock” occurrence has already taken place,
• the brake is depressed while vehicle speed is less than 5 km/h
(3 mph),
• all vehicle doors become closed again, and
• the vehicle speed increases to 5 km/h (3 mph), or greater.
Deactivating/activating the autolock feature
The deactivating/activating the autolock feature can be turned off by the
keyless entry keypad (if equipped) on your door, driver configuration
mode or by your dealer.
2004 Monterey (mty)
Owners Guide (post-2002-fmt)
USA English (fus)
Locks and Security
94
To Next Page
Loading...
Need help?
General
