To power open or close the PSD
from the Overhead console:
Push and release the overhead
console right or left hand control.
Pressing this control will also
simultaneously unlock all doors.
To power open or close the PSD
from the second row passenger
control switch:
• Ensure that the PSD is unlocked,
using the key fob or power door
unlock. Refer to Remote Entry
System in the Locks and
security chapter.
• Push and release the right or left hand second row passenger control.
The control(s) are located on the trim panel in front of the sliding
door.
To power open the PSD with the inside or outside release handle:
• Ensure that the PSD is unlocked, using the key fob or power door
unlock. Refer to Remote Entry System in the Locks and security
chapter.
• Manually pull the inside or outside sliding door handle to engage the
power assist feature. Release the handle as soon as the PSD begins to
power open.
To power close the PSD with the inside or outside release handle:
• Manually pull the door about 6 inches in the desired direction of
travel. The power door assist will take over and complete the open or
close operation.
Pressing any of the switches, overhead console, second row passenger, or
remote transmitter while the door is moving will cause the door to either
reverse direction or stop depending on the position and direction of
movement of the door.
To power open or close the PSD with the Key fob:
Refer to the Remote entry system section in this chapter. Operating the
transmitter will also simultaneously unlock the doors.
2005 Monterey (mty)
Owners Guide (post-2002-fmt)
USA_English (fus)
Driver Controls
60
To Next Page
Loading...
Need help?
General
