Mercury 350Verado FourStroke User Manual

2. Disconnect the flush connector from the fitting on the bottom cowl.
28726
3. Thread a water hose into the flush fitting.
28727
4. Turn on the water tap (1/2 maximum) and let the water flush through the
cooling system for about 15 minutes.
5. When flushing is complete, turn off water and disconnect the water hose.
6. Install the flushing connector to the fitting on the bottom cowl. Tighten the
connector securely.
Cowl Removal and Installation
COWL REMOVAL
IMPORTANT: Most maintenance points are accessible by removing the top
cowl only.
1. Pull up on the top cowl lock latch.
28946
MAINTENANCE
eng 87

Mercury 350Verado FourStroke Specifications

General

Cylinders	8
Starting	Electric
Gear Ratio	1.75:1
Fuel Type	Gasoline
Full Throttle RPM Range	5800-6400
Fuel Induction System	Electronic Fuel Injection (EFI)
Horsepower	350 hp
Shaft Length	20", 25", 30"
Engine Type	V8 FourStroke