DRAINING GEARCASE
1. Tilt the outboard so that the oil drain plug is at the lowest point.
2. Place the drain pan below the outboard.
3. Remove the vent plug and fill/drain plug and drain lubricant.
a - Vent plug
b - Fill/drain plug
GEARCASE LUBRICANT CAPACITY
Gearcase lubricant capacity is approximately 195 cc (6.6 fl oz).
GEARCASE LUBRICANT RECOMMENDATION
Mercury or Quicksilver Premium or High Performance Gear Lubricant.
CHANGING GEAR OIL
1. Place outboard in a vertical operating position.
2. Remove the oil drain plugs (upper and lower), and completely drain the
gear oil into a pan.
NOTE: If water in the oil, giving it a milky colored appearance, contact your
dealer.
a - Oil drain plug (upper)
b - Oil drain plug (lower)
To Next Page
Loading...
Need help?
General
