MAINTENANCE
90-827242R02 FEBRUARY 2003 Page 1B-7
Battery Inspection
The battery should be inspected at periodic intervals to ensure proper engine starting
capability.
IMPORTANT: Read the safety and maintenance instructions which accompany your
battery.
1. Turn off the engine before servicing the battery.
2. Add water as necessary to keep the battery full.
3. Make sure the battery is secure against movement.
4. Battery cable terminals should be clean, tight, and correctly installed. Positive to positive
and negative to negative.
5. Make sure the battery is equipped with a nonconductive shield to prevent accidental
shorting of battery terminals.
Fuse Replacement – Electric Start Remote Control Models
The electric starting circuit is protected from overload by a SFE 20 AMP fuse. If the fuse is
blown, the electric starter motor will not operate. Locate and correct the cause of the
overload. If the cause is not found, the fuse may blow again. Replace the fuse with a fuse
of the same rating.
1. Replace with a new SFE 20 AMP fuse.
a
a-SFE 20 amp fuse
To Next Page
Loading...
Need help?
General
