Mercury HP 500 EFI Bravo XR/XZ/III - Page 101

97500 EFI Bravo
MAINTENANCE
Lubrication (cont.)
DRIVE UNIT AND TRANSOM ASSEMBLY
1 Lubricate gimbal bearing with 2-4-C with Teflon Lubricant P/N
(92-825407A12).
NOTE: Engine coupling and shaft splines are greased with Engine
Coupler Spline Grease, P/N 92-816391A4; universal joints are
greased with Quicksilver 2-4-C with Teflon Lubricant P/N
(92-825407A12). Contact your Authorized MerCruiser Dealer for this
service.
IMPORTANT: Stern drive must be removed to lubricate U-
joints. Contact your authorized MerCruiser dealer for this ser-
vice.
CAUTION
Speedometer water hose must be disconnected from drive
unit BEFORE removing drive unit. Failure to do this will result
in a broken fitting if drive unit is removed.
CB56
ENGINE COUPLER
2 Lubricate engine coupler and shaft splines with Quicksilver En-
gine Coupler Spline Grease P/N 92-816391A4.
CB57
DRIVE SHAFT EXTENSION MODELS
3 Lubricate drive shaft grease fittings, at transom end, with 2-4-C
with Teflon Lubricant P/N (92-825407A12).
4 Lubricate drive shaft grease fittings, at engine end, with 2-4-C
with Teflon Lubricant P/N (92-825407A12).