EasyManua.ls Logo

Mercury HP 500 EFI Bravo XR/XZ/III - Power Trim Does Not Operate (Motor Doesnt Run); Power Trim Does Not Operate; Does Not Move)

Mercury HP 500 EFI Bravo XR/XZ/III
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
133500 EFI Bravo
TROUBLESHOOTING
Battery Will Not Come Up On Charge (cont.)
Possible Cause Remedy
Alternator drive belt loose or in
poor condition.
Replace and/or adjust.
Unacceptable battery
condition.
Test battery.
Power Trim Does Not Operate (Motor Doesn’t
Run)
Possible Cause Remedy
Blown fuse. Replace fuse.
Loose or dirty electrical
connections or damaged
wiring.
Check all associated electrical
connections and wires
(especially battery cables).
Clean and tighten faulty
connections. Repair or replace
damaged wiring.
Power Trim Does Not Operate (Motor Runs But
Drive Unit Does Not Move)
Possible Cause Remedy
Trim pump oil level low. Fill pump to correct level.
Drive unit binding in gimbal ring. Check for obstruction.

Table of Contents

Related product manuals