Mercury HP 500 EFI Bravo XR/XZ/III - Page 105

101500 EFI Bravo
MAINTENANCE
CB421hp
Propellers (XR, XZ Models)(cont.)
CB
INSTALLATION
4 Install Bravo XR/XZ Replaceable Hub Propeller Compo-
nents in Order shown:
a-Apply Lubricant to entire exposed surface of Propshaft.
Salt Water: Anti-Corrosion Grease (92-78376A-6)
Fresh Water: Anti-Corrosion Grease or Optimal Paste White
T Grease (92-847206)
b-Install prop hub assembly into propeller if removed
c-Propeller Assembly
d-Washer
e-Belleville Washer
f-Washer
g-Locknut
• Tighten propeller nut to a minimum of 55 lb-ft (75 Nm).
After first use:
• Retighten propeller nut to minimum 55 lb-ft torque (75 Nm).
• Check propeller at least every 20 hours of operation.
• Do not operate with loose propeller.