Need help?Do you have a question about the Mercury Quicksilver 200 Tendy Slatted and is the answer not in the manual?
Process for transferring the limited warranty to a new owner.
Requirements for eligible warranty coverage and dealer submission.
Specifies the parts and components covered by the limited warranty.
Outlines the period for which the warranty is valid.
Details Mercury Marine's obligations under the warranty.
Lists items and conditions excluded from warranty coverage.
Disclaims implied warranties and excludes incidental/consequential damages.
Operator's duties for safe operation and occupant safety.
Function and operation of the engine kill switch for safety.
Importance of the lanyard stop switch for preventing accidents.
Precautions when approaching or near people in the water.
Risks associated with operating over waves and wakes.
Importance of controlling speed to reduce impact damage.
Awareness of CO hazards and importance of good ventilation.
Importance of PFDs and not exceeding load capacity.
Covers obeying rules, avoiding influence, proper loading, and seating.
Step-by-step guide to re-enter the boat if fallen overboard.
Technical specifications for Tendy light tender models.
Technical specifications for Air Deck inflatable boats.
Technical specifications for Sport models with aluminum floors.
Technical specifications for Sport HD models with aluminum floors.
Technical specifications for ALU RIB models.
Technical specifications for larger ALU RIB models.
Categories defining seaworthiness based on wind and wave conditions.
ISO 6185 categories defining power ratings for boats.
Explanation of the details found on the boat's capacity plate.
Conformity statement for inflatables under 2.50m.
Identification of external transom and front view components.
Identification of cockpit and side view components.
Guidelines for safely transporting the boat on a trailer.
Instructions for installing floorboards in models with aluminum floors.
Explanation of floorboard numbering and use of side joiners.
Installation details for five and six board floor models.
How to install stringers into the floor assembly.
Steps for installing and securing the air deck floor assembly.
Procedure for inflating the air deck floor to recommended pressure.
How to operate and maintain Quicksilver boat valves.
Steps to open and close the boat's air valves.
Instructions for using the hand pump in single or double action modes.
Procedure for inflating the boat's air chambers sequentially.
Instructions for floorboard and valve assembly/disassembly.
How to install oars, oarlocks, and seats.
How to operate drain valves for water drainage.
Correct sequence for inflating chambers and safety notes.
Step-by-step inflation and pressure warnings.
Essential checks to perform before operating the boat.
Guidelines for safe loading and passenger seating.
Procedures for towing and managing accidental air chamber deflation.
Precautions for beaching and storing the boat.
Safety guidelines for refueling and considerations for high altitude use.
Steps for cleaning the boat and its components.
Instructions for properly deflating the boat's air chambers.
Steps for folding the deflated boat for storage.
How to detect and address air leaks in the boat.
How to inspect valves for damage and replace if necessary.
Procedures for repairing Hypalon fabric air chambers.
Procedures for repairing PVC fabric air chambers.
Steps for preparing the boat for long-term storage.
Guidance on returning the outboard to an authorized dealer for service.
How to find service when away from the local authorized dealer.
How to inquire about and order replacement parts and accessories.
Steps to take if you have a problem with your Mercury product.
Contact information for Mercury Marine customer service by region.
How to order additional literature for your power package.
To Next Page
General