the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.
Do not use extensions to change the fit of the shoulder belt
across the torso.
Safety belt maintenance
Inspect the safety belt systems periodically to make sure they work
properly and are not damaged. Inspect the safety belts to make sure
there are no nicks, tears or cuts. Replace if necessary. All safety belt
assemblies, including retractors, buckles, front seat belt buckle
assemblies, buckle support assemblies (slide bar-if equipped), shoulder
belt height adjusters (if equipped), shoulder belt guide on seatback (if
equipped), child safety seat LATCH and tether anchors, and attaching
hardware, should be inspected after a collision. Ford Motor Company
recommends that all safety belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision was minor and a qualified
technician finds that the belts do not show damage and continue to
operate properly, they do not need to be replaced. Safety belt assemblies
not in use during a collision should also be inspected and replaced if
either damage or improper operation is noted.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Interior in the Cleaning chapter.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM
A
VOL
PUSH ON
AM
FM
H
M
EJ TAPE
BASS
TREB
BAL
FADE
SCAN
REW
FF
R
COMP
OFF
A/C
MAX
A/C
SHUFFLE
SIDE 1-2
CD
SEEK
TUNE
DISC 1-6
1 23456
P!
BRAKE
+–
CRUISE
RPMx1000
ABS
0
1
2
3
4
5
6
7
20
60
140
180
100
km/h
P R N D 2 1
000000
0000
E
F
C
H
FUEL DOOR >
THEFT
LOW
COOLANT
ON
SET+
RES
CST-
OFF
Seating and Safety Restraints
91
To Next Page
Loading...
Need help?
General
