Her türlü değişiklik hakkı saklıdır.
KLV-09/Yayın Tarihi : 09.03.2023/Revizyon No: 00 /Revizyon Tarihi:
Sayfa :
Güncel dokümanlar için www.merihasansor.com adresini ziyaret ediniz!
Belirtilmeyen tüm ölçü birimleri milimetredir.(mm)
DDC70/DDC80
2.Introduction
This guide is for informational purposes and has been prepared for Merih DDC70 and DDC80 driver
boards.All pictures, details and information in this booklet belong to Merih Asansör A.Ş. It cannot be
copied, reproduced, stored or backed up in whole or in part without permission. Merih reserves the right
to make changes and improvements in any details described in this document without prior notice. Merih
does not take responsibility for any errors or incorrect information that may occur in the content of this
manual. The warranty period of the products is 2 years from the date of sale of the product.
Thank you for taking the above warnings into consideration and choosing the products of Merih Asansör
A.Ş.
2.Information
2.1.First Use
If you are using the Merih DDC70 and DDC80 door control card (and / or its additional equipment)
for the first time, please read this document and the most up-to-date auxiliary documents published by
considering all warnings. It is essential for safety to be fully learned the installation and usage
information of the device (and its components).The personnel who will use Merih DDC70 device and its
auxiliary equipment should also know how to make the assembly and electrical connections of these
products, as well as learn the functions of the products. In order to prevent the possibility of electric
shock and / or damage to the device and / or injury and / or unexpected mechanical movements that
may cause material damage; Care should be taken;
· To ensure that the power plug must be unplugged during the installation of the device and
before it is started up for the first time,
· To ensure that all electrical connections required in the existing field are in correct and tight
contact,
· To behave electrostatically sensitive (ESD compliant).
For this, the electricity in the person's body should be discharged into the ground or a large metal object
and should be electrostatically discharged. The connector pins and circuit elements on the device
should not be touched with bare hands.
Her türlü değişiklik hakkı saklıdır.
KLV-09/Yayın Tarihi : 09.03.2023/Revizyon No: 00 /Revizyon Tarihi:
02
To Next Page
Loading...