10.4 Release trigger and wait for tool to stop before removing battery pack. Removal of battery pack or cartridges
during operation is prohibited. This could cause damage to tool or personal injury.
10.5
WARNING: When not in use, turn speed control to its minimum setting and remove battery pack. This
prevents tool from starting unintentionally.
,
10.6 Do not fix trigger in the “ON” position by any means (rubber band, tape, etc.). This may result in an unsafe
operating condition.
10.7 Do not operate without pistons attached. This will damage the cartridge and may be dangerous.
10.8 Use only with batteries of rated voltage and same type. Higher voltages may create an electrical hazard. Other
battery types may fall from tool, creating a risk of personal injury.
DEFINITION OF ALL SYMBOLS USED ON THE TOOL
V volts
_ _ _ direct current
dose
speed
DANGER!
KEEP HANDS AWAY!
© 2005 Meritool, LLC
5
To Next Page
Loading...