Merlin GRIFCO STAR1000EVO - User Manual

1
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is NOT connected BEFORE installing the receiver.
To prevent possible SERIOUS INJURY or DEATH from a moving residential gate,
residential garage door or a commercial door:
REVEN .nerdlihc fo hcaer fo tuo slortnoc etomer peek SYAWLA •
permit children to operate, or play with remote control transmitters.
ylreporp si ,ylraelc nees eb nac ti nehw YLNO rood ro etag etavitcA •
adjusted, and there are no obstructions to door travel.
ALWAYS keep residential gate, residential garage door or commercial door in
sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
•
To prevent possible SERIOUS INJURY or DEATH, the use of
CONSTANT OPERATION on residential openers is PROHIBITED.
When a receiver is used to activate a commercial door opener, a
reversing edge MUST be installed on the bottom of the door. Failure to
install a reversing edge under these circumstances may result in
SERIOUS INJURY or DEATH to persons trapped beneath the door.
COMMERCIAL ACCESS CONTROL RECEIVER
MODEL STAR1000EVO
Control
Station
Receiver Without
Faceplate
Single Operator
9 - 30 volts AC/DC
250 mA max
Power
(not provided)
Supply
APPLICATION
The STAR1000EVO is a high capacity single channel commercial access
control receiver for commercial door openers, and dry contact triggered
devices. The STAR1000EVO is compatible with Security 2.0™ remote
+
controls and wireless keyless entries. The receiver capacity is 1,000
devices and can be any combination of remote controls and wireless
keyless entries. The receiver is watertight according to IPX44
specification.
INSTALLATION
ener to be controlled by thepo eht raen noitacol tneinevnoc a tceleS .1
receiver within “line of sight” of the intended transmitting location.
E:TON Do not mount LCD screen in direct sunlight. Avoid mounting
the receiver in a metal enclosure or near other wireless receiving or
transmitting devices.
erawdrah etairporppa htiw ecafrus derised eht ot tekcarb eht tnuoM .2
(not provided) (Figure 1).
eht evomer dna reviecer eht fo kcab eht no swercs )8#( 4 eht evomeR .3
faceplate. Unplug the keypad connector from the control board.
:ETON Be careful not to damage the keypad cable while removing the
faceplate.
l
aicremmoc ro etag ruoy ot refeR .)2 erugiF( snoitcennoc gniriw ekaM .4
door opener owner’s manual for more specific information.
5. Reconnect the keypad connector to the board (labeled J9).
6. Secure the faceplate with the 4 (#8) screws previously removed.
7. Install the antenna provided.
:ETON Use the optional ANT4X-1LM antenna extension kit
(see page 4) to mount the remote antenna as high and far from
metallic objects as possible for best radio range.
e 2ht htiw eruces dna tekcarb gnitnuom eht otno reviecer eht panS .8
(#8) screws provided.
9. Tighten the watertight connector to secure and seal the wiring.
Figure 1
Mounting Bracket
Watertight Connector
Keypad Connector
Antenna
Connector
Figure 2
Backup Memory
Module
Relay
Connection
Power
Connection

Summary

Product Application and Safety

Commercial Receiver Application

Describes the STAR1000EVO as a high capacity single channel commercial access control receiver.

Installation Instructions

Step-by-step guide for installing the STAR1000EVO receiver, including mounting and wiring.

Electrical and Safety Warnings

Critical warnings regarding electrocution, moving doors, and proper use of reversing edges.

User Interface and Programming

STAR1000 EVO User Interface

Details the LCD display, soft keys, navigation arrows, and numeric keypad of the receiver.

Receiver Programming

Explains how to program the receiver, including setting an initial PIN.

Advanced Functions and Diagnostics

Programming Commands Overview

Lists and describes commands for learning, deleting, suspending devices, querying locations, and settings.

Diagnostics and Event Notifications

Details audible notifications for programming and error events, and how to reset the PIN.

Product Specifications and Support

Technical Specifications

Provides key technical details such as system capacity, voltage, current, temperature, and frequency.

Compatible Accessories

Lists compatible Merlin and Grifco remote controls, keypads, wireless wall buttons, and antenna kits.

Technical Support Contact Information

Provides toll-free numbers and websites for technical support in Australia and New Zealand.

Merlin GRIFCO STAR1000EVO Specifications

General

Brand	Merlin
Model	GRIFCO STAR1000EVO
Category	Receiver
Language	English