11. Operation for remote
MED
HILOW
STOP
2H
4H
1H
R/F
LI
Installation of transmitter wall
Mount holder with two screws.
1. speed control button of fan: HI. MED AND LOW
are speed button.
2. LI :ON/OFF the lamp
3. STOP :Turn off the ceiling fan.
4. Fan timing button: 1H.2H and 4H.
5. F/R : Controls the direction of the fan
"Forward and Reverse".
6. Battery for RF emitter: 12V 23A
Bettery foremitter:UM-44 AAARo3 DC 1.5Vx2.
7. RF emitter:Renote control distance at 25-30 meters.
emitter:Remote control distance within 10 meters.
KINDLY REMINDERS:
Learning code maching mode is useed between emitter and receiver,Turn "ON" the supply power
within 30 seconds and press the emitter's "LI" and "Hi"button for 3 seconds, it can load normally
after hearing the "BEE" which means learning successfully and it can works normally.(PS:Learing
mode is not acepted after turn "ON" the supply power for 30 seconds)
RED
TO FAN REVERSE L
TO FAN REVERSE N
ORANGE
8
To Next Page
Loading...