Merritt Buckle Guard User Manual

NOTE: This buckle guard is
designed to prevent the
occupant from releasing the
buckle.
NOTE: Do not use this
product if caregiver is
unable to release the buckle
with the buckle guard
installed.
NOTE: This buckle guard
(Figure A) must only be
used with the buckle shown
in Figure B. If there is any
doubt, call customer service
at Merritt Manufacturing,
Inc. at 317-409-0148 for
assistance.
Buckle
Anchor
Installation of the Buckle Guard
1. Remove the buckle from
your child safety seat, per
the instructions provided
with it.
2. Remove the Buckle Guard
(Figure D) from its
packaging.
3. Insert the buckle anchor
through the top of the
Buckle Guard (Figures E and
F).
4. Using the palm of your hand,
snap the Buckle Guard onto
the buckle (Figure G).
NOTE: Make sure the
buckle guard fits flush as
shown in Figures H and I. If
it does not fit flush, call
customer service at Merritt
Manufacturing, Inc. at 317-
409-0148 for assistance.
5. Install the buckle, according
to your child safety seat’s
instructions.
6. Instructions continued on
back of page.
D
E
F
G
H I
NOTE: This Buckle Guard (Figure A) will not work with any
of the buckles pictured above. It will only work with the
buckle shown in Figure B below.
A
C
Buckle
B

Merritt Buckle Guard Specifications

General

Brand	Merritt
Model	Buckle Guard
Category	Automobile Accessories
Language	English

Summary

Installation of the Buckle Guard

Buckle Guard Installation Steps

Steps for installing the buckle guard onto the buckle, including inserting the anchor and snapping the guard.

Buckle Guard Compatibility and Use

Notes on buckle guard compatibility, proper usage with the specified buckle, and contact for assistance.

Using and Removing the Buckle Guard

Opening the Buckle with Guard

Instructions on two methods for releasing the buckle while the guard is installed.

Removing the Buckle Guard

Steps for permanently removing the buckle guard, with safety notes on reusability and buckle damage.