Mesa MSL-500 - Setting Time Delay; Time Delay Configuration; How to Open in Time Delay; Time Delay Opening Procedure

Page 5
Dual User Mode (continued)
• Example: - 1 - 5 - 8 - # - Master Code - # - 2 - #.
• Unsuccessful Code Change: five beeps, repeat steps 1 - 4.
• The Master Code will override dual user mode.
• Please see HOW TO OPEN YOUR SAFE on page 2 to use this mode.
SETTING TIME DELAY (1 to 59 minute time delay)
1. Input: (the lock will beep twice)
2. Input: 1 - 5 - 9 - # (the lock will beep twice)
3. Input: Current Master Code - # (the lock will beep twice)
4. Input: (00 - 59) - # (light stays green for three (3) seconds)
01 = 1 minute time delay
59 = 59 minute time delay
00 = Will turn time delay mode off
• Example: - 1 - 5 - 9 - # - Master Code - # - 03 - #.
(This will set the time delay period to 3 minutes).
• Unsuccessful Code Change: five beeps, repeat steps 1 - 4.
• The Master Code will override the time delay.
How to open in time delay
1. Enter any valid code other than the Master Code.
2. Once the code is entered the time delay will activate.
3. During the time delay, codes will not be accepted, when you
press any key the light will stay orange for three (3) seconds.
4. The lock will beep continuously and the light will stay green for
the last thirty (30) seconds of the time delay period.
5. Once the continuous beeps stop, the lock will unlock for five (5)
seconds.
6. Turn the handle to open safe.
Low Battery Warnings
• Red light appears when you open the safe other than the green light.
• Enter your code and get a valid response but the lock doesn’t unlock.