Selecting shot-steam (E) and steam when ironing vertically
Ironing without steam
To ironing without steam, turn steam regulation lever (C) to 0 position.
Using steam boost button (at the correct time between of use) can also be ironed iron in a vertical position (curtains, hanging clothes,
etc.).
Warning: The iron gives off steam continuously only if you hold the iron horizontally. You can stop the continuous steam by placing the
iron in a vertical position or by moving the steam selector to “0”. As indicated on the thermostat knob (I) and in the initial table, you can
only use steam at the highest temperatures. If the selected temperature is too low, water may drip onto the plate.
Warning: The Shot of steam function can be used only at the highest temperatures. Do not use the button when thermostat indicator
lits. You can return to the vertical ironing only if the pilot light goes out.
STEAM IRONING
Press the steam blast button to cause rapid ejection of a strong jet of steam, which easily penetrates the fabric and can smooth out
most wrinkles. Wait a few seconds before re-use this button.
Warning: When you ironing, the thermostat control light turns on from time to time, this means that the selected temperature is
maintained at a constant level. If you decrease temperature, do not begin ironing again until the thermostat light does not light up.
Check that the plug is disconnected from the socket. Move the steam selector (C) to “0” . Open the lid (B). Raise the tip of the iron to
help the water enter the opening without overflowing. Slowly pour the water into the reservoir using the special measure and taking care
not to go over the maximum level (about 250ml) indicated by “MAX” on the reservoir. Close the lid (B). Place the iron in a vertical
position. Plug it to the electricity. Set the thermostat knob in accordance with the international symbol on the cloth’s labels. Thermostat
control light indicates that the iron heats up. Wait until the indicator light off. You can then start ironing.
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Use self-cleaning function at least once a month.
24. Iron must be used at a stable even surface and this can only be disposed of.
20. If you do not use iron, even for a short time, turn off the options of steam
25. Do not fill the water tank with chemicals, perfumes or descaling substance.
19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of fabric.
G. Thermostat knob - temperature control H. Thermostat indicator light
E. “Steam blast” button F. Power Cord
IRONING
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics. This
is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first time.
A. Spray nozzle B. The water inlet hole
C. Steam Control Lever D. Spray button
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
First use
DESCRIPTION OF DEVICE
I. Steel soleplate J. Water tank
Preparation
GARMENT
LABEL
FABRIC
TYPE
THERMOSTAT
REGULATION
synthetic
·
low temperature
silk - wool
··
medium temperature
Cotton - linen
···
high temperature
Fabric not to be ironed
4
To Next Page
Loading...