Why my Messersi TC50 engine does not start?
If the Messersi Farm Equipment engine doesn't start, make sure the start-up starter or switch is in the correct position as shown in the engine user's manual. Also, check the fuel tank and refuel if it's empty, and verify that you're using the correct fuel. If the wrong fuel was used, clean out the tank and replace it with the correct one.
What to do if one of the two tracks is blocked on my Messersi Farm Equipment?
If one of the tracks on your Messersi Farm Equipment is blocked, it could be due to a hydraulic motor failure, in which case you should contact an authorized workshop. Alternatively, the pump or hydraulic piping might be damaged; check these components and replace them if necessary.
Why is the hydraulic oil overheated in my Messersi TC50?
If the hydraulic oil in your Messersi Farm Equipment is overheated, it may be due to a low hydraulic oil level. Check the level and restore if necessary.
Why Messersi TC50 Farm Equipment does not achieve maximum performance?
If your Messersi Farm Equipment isn't using all its power and isn't achieving maximum performance, the hydrostatic system oil filter might be plugged. Replace the filter cartridge to resolve this issue.
What to do if Messersi Farm Equipment moves jerkily?
If your Messersi Farm Equipment moves jerkily, the hydrostatic system oil filter might be plugged. Replace the filter cartridge to solve this problem.
What to do if the raised dump body does not descend on my Messersi TC50?
If the raised dump body on your Messersi Farm Equipment does not descend, there might be a mechanical impediment; remove any obstacle. Alternatively, the articulation pin could be blocked, or the cylinder or gasket might be damaged. Check and replace these parts if necessary.
Why the dump body does not rise on my Messersi Farm Equipment?
If the dump body on your Messersi Farm Equipment does not rise, it could be due to a joint and/or hydraulic pump failure. Check these components and replace them if necessary.
What to do if Messersi TC50 doesn't move?
If your Messersi Farm Equipment doesn't move in either driving direction even when the levers are moved, it could be due to a broken hydraulic pipe, which should be checked and replaced if necessary. It may also be caused by a damaged pump or hydraulic motor, in which case you should contact an authorized workshop.
What to do if the dump body hatch does not open or close on my Messersi TC50?
If the dump body hatch on your Messersi Farm Equipment does not open or close, the hook device might be damaged. Check the lever, seat, etc., and restore the original condition if necessary.
Why the tracks tend to jump on my Messersi TC50 Farm Equipment?
If the tracks on your Messersi Farm Equipment tend to jump, the track may have loosened. Adjust it following the indications reported in the paragraph on "CHECKS AND CONTROLS" under GENERAL MAINTENANCE.
General| Brand | Messersi |
|---|---|
| Model | TC50 |
| Category | Farm Equipment |
| Language | English |
To Next Page