THIEN MINH MECHANICAL - ELECTRIC JSC
Head office: MESTAR Building, No. 98/11 Ung Van Khiem Street, Ward 25,
Binh Thanh District, Ho Chi Minh City, Vietnam
Tel: (84) 28.3899 4790 - Email: mestar@mestar.vn - Web: www.mestar.vn
We reserve the right to make technical and design changes.
Ha Noi Office: TT4.18, Xuan Phuong Tasco Urban Area, Xuan Phuong Ward,
Nam Tu Liem District, Hanoi City, Vietnam.
Tel: (84) 24.3222 2411
TINY - LED RECESSED DOWNLIGHT
。
75mm
75mm
50mm
1. Unpack the lighting fixture and check whether there is any damage. Then
read the installation manual before installation.
2. Turn off the power before installation.
3. Open a hole on the ceiling by tools. 4. Connect the pre-installed wires to the lamp driver, place the driver behind
the ceiling from the open hole. Attention! The drive cannot be covered.
5. Fold up the three shrapnel of the downlight, then install the downlight to the hole as shown to make sure the downlight cannot fall off.
6. Make sure the distance between the downlight and the object as shown. The downlight cannot be covered.
7. Switch it on to check the lighting effect and adjust the lamp direction for the target of accent lighting. Installation accomplished.
INSTALLATION MANUAL
IP20
To Next Page
Need help?
General