Need help?Do you have a question about the Mestra Autopol Geisser and is the answer not in the manual?
General| Category | Laboratory Equipment |
|---|---|
| Type | Automatic Polarimeter |
| Accuracy | ±0.01° |
| Display | LCD |
| Interface | RS232 |
| Power Supply | 220V, 50Hz |
| Light Source | Sodium Lamp (589.44 nm) |
Program selection.
Edition of time and temperature values.
Access to edition of temperatures.
Open the lid and pour water into the tank.
Activate the main switch. The green light will come on.
Select the program you wish to run.
Press key to start the program. Pilot light indicates heating.
Hold down the key for a few seconds to terminate a program underway.
Automatic pressurisation for temperatures equal to or less than 60 °C.
Manual pressurisation for temperatures higher than 60 °C.
To Next Page
