Meta System M43JT User Manual

10
MSM43J(T)1702020
The Immobiliser clicks when trying the start the vehicle:
a. Ensure the wires ‘KEY’ and ‘3A’ have been inserted into the 2-way connector supplied.
b. Ensure the ignition connection is not on the dead side of the cut i.e. it must remain live when the cut is
open.
The Immobiliser does not ARM:
a. Ensure the immobiliser is not in VALET mode; insert the service key to toggle.
b. With the ignition OFF, ensure wire No. 5 has no residual voltage. If you are unsure try disconnecting
the and re-check arming.
+44(0)208 867 2340
Mon-Fri 9am-5pm for installation support
www.vestatec.co.uk
Distributed in the UK and the Republic of Ireland by:
Vestatec Distribution Limited
Unit 8, The Links
Popham Close
Hanworth
Middlesex TW13 6JE

Meta System M43JT Specifications

General

Brand	Meta System
Model	M43JT
Category	Automobile Accessories
Language	English