SAT RC 09
INSTALLATION MANUAL
CAUTION
- Only carry out the operations described in this manual.
- The installer is not authorized to remove the warranty seals or to access the interior parts of the products or accessories.
- The installer is not authorized to modify and/or adapt the product or the relative accessories.
- The manufacturer declines all liability for damage to persons and/or property caused by incorrect installation of the product.
TECHNICAL SPECIFICATIONS
Dimensions and weight:....................................................................................104X75X27, 168g
Power supply voltage:................................................................................................12 VDC
Temperature:..........................................................................................................-25º+70ºC
Power input*:.............................................................................................................<2mA
*With the peripheral device connected, the GPS off, Sat Programmer disconnected and the internal
buffer battery charged.
Maximum current:.............................................................................................................<210mA
DISCONNECT THE VEHICLE’S BATTERY
GROUND
BATTERY
POSITIVE
(+12V)
IGNITION
KEY POSITIVE
(+15)
GSM
ANTENNA
1
EN
PRESS
TO RELEASE
GPS
ANTENNA
Release and position the lever
as shown in the figure before
connecting the 18-pin loose
connector to the terminal.
CONNECTOR
CONNECTIONS
Lock the connector to the terminal by positioning the lever
as shown in the figure.
Connect the connectors
to the terminal
PHASE
2
PHASE
3
PHASE
Fig.2
Fig.3
Fig.4
WARNING: make sure that the connector is inserted
and locked to the terminal in the correct way.
* : MANDATORY
5040273800
+15
5A
SAT
PROGRAMMER
*
+12
GND
Fig.1
DARK BLUE
MAROON
GENERAL LAYOUT
See pic. 5
To Next Page
Need help?
General
