WIRING - METAL PANELS
GPS
DIRECTIONAL
ANTENNA
ATTENTION: make sure that the telematic control unit is
at least 50 cm from the ECU (engine control unit).
ATTENTION
If horizontal installation is not possible, pro-
ceed with vertical installation.
Do not secure the telematic control unit
with the cables set up upwards!!
TELEMATIC CONTROL UNIT: WARNINGS ON DEVICE POSITIONING
TELEMATIC CONTROL UNIT: INSTALLATION
Below is some information on positioning and mounting the telematic control unit:
• Identify a at area for mounting.
• Clean the area with the supplied detergent wipe and remove the adhesive lm from the telematic control unit.
• Position and mount the telematic control unit by pressing for at least 10 seconds.
IN HORIZONTAL POSITION
3