ENGLISHen
10
Observe the national regulations on
environmentally compatible disposal and on the
recycling of disused tools, packaging and
accessories.
Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
D
max
=maximum support plate diameter
M
t, max
=maximum torque
M=Spindle thread
l =Length of the sanding spindle
n* = No-load speed (maximum speed)
I
120 V
=Current at 120 V
n
S
=No-load speed depending on the thumb-
wheel position
n
N
* =Speed at rated load
P
1
=Rated input power
P
2
=Power output
m =Weight without mains cable
* Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations
disappear, however, as soon as the interference
fades away.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value
(vector sum of three directions)
determined in accordance with EN 60745:
a
h, DS
=Vibration emission value (sanding
surfaces)
a
h, P
=Vibration emission value (polishing)
K
h,DS
/K
h,P
=Uncertainty (vibration)
Typical A-effective perceived sound levels
:
L
pa
=Sound-pressure level
L
WA
=Acoustic power level
K
pA
, K
WA
= Uncertainty
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
12. Environmental Protection
13. Technical Specifications
To Next Page
Loading...
Need help?
General