To Next PageTo Next PageWhat to do if no chains are moving on my Metal-Fach Farm Equipment?
If the chains are not moving, it's likely that the M6x35-8.8 bolts in the pickup drive overload coupling have sheared. Replace them with M6x35-10.9 bolts (1 piece) on the left side of the press.
What to do if the pickup is clogged on Metal-Fach Farm Equipment?
If the pickup is clogged, stop the tractor, turn off the engine, and then remove the clog.
Explains the meaning of various warning symbols used on the machine.
Outlines essential safety rules for operating and maintaining the baling press.
Details crucial safety precautions for operation, maintenance, and transport.
Explains how to couple the baling press to the tractor's lower hitch.
Guides on connecting the baling press to the tractor's rear PTO shaft.
Instructions on how to safely disconnect the baling press from the tractor.
Details the process and checks for commissioning a new baling press.
Guides on adjusting the bale compression ratio based on material type.
Covers cord installation and the wrapping assembly.
Introduces the hydraulic system powering the baling press.
Describes the optional hydraulic system powered by the tractor.
Describes the operating principle and functional steps of bale wrapping.
Describes the standard hydraulic system configuration.
Covers procedures and precautions for driving the baling press on public roads.
Identifies residual risks resulting from incorrect operator actions.
Provides guidelines for assessing and mitigating residual risks.
General| Bale diameter | 1200 mm |
|---|---|
| Bale width | 1200 mm |
| Pickup width | 1.8 m |
| Type | Round Baler |
| Twine | Yes |
| Binding type | Twine |
| Power demand | 50 HP |
| Power | 50 HP |
| Capacity | Up to 30 bales/hour |
| Bale chamber | Fixed chamber |
