Need help?Do you have a question about the Metallkraft UB 10 and is the answer not in the manual?
Contact your dealer for questions and technical advice regarding the bending machine.
Explanation of safety symbols and signal words used to indicate risks in the manual.
Defines operator, qualified, and specialist personnel requirements for safe machine operation.
Details essential PPE like eye protection, gloves, and safety boots for user safety.
General guidelines and precautions to ensure safe operation and prevent accidents.
Specifies that the machine must be in a technically perfect condition for safe and proper operation.
Instructions for mounting and securing the machine at a suitable location.
Explains how to use the eccentric counter-holder for securely clamping material during bending.
Details the process for creating U-shaped tabs using the bending machine.
Describes the method for bending and producing handles with the machine.
Provides steps for manufacturing pipe supports using the bending machine.
Guide on using the bending segment accessory for creating spirals.
Instructions for using the accessory for bending heating pipes.
Details on using clamp and adjustable stop accessories for precise bending.
Routine care procedures to keep the machine in good operating condition.
Guidelines for performing repairs and when to contact customer service.
Procedures for safely decommissioning and disposing of the machine and packaging.
Information on how to identify and order replacement parts for the machine.
General| Cutting capacity round steel | 10 mm |
|---|---|
| Cutting capacity square steel | 10 mm |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Motor power | 750 W |
To Next Page
