EasyManua.ls Logo

Metasys COMPACT Dynamic - Page 18

Metasys COMPACT Dynamic
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN | Use
18
Error message Externe Anzeige Possible cause Countermeasures
LED1ashesgreen
LED3ashesyellow
Buzzer tone can be
switched off via RESET
RESET
RESET
RESET
RESET
RESET
RESET
LEUCHTEN
BLINKEN
1
RESET
RESET
2
RESET
RESET
3
RESET
RESET
4
RESET
RESET
1
2 3
4
Motor overtemperature Notify your service technician.
LED 1 glows green
LED 3 glows yellow
+ buzzer tone can be
switched off via RESET
RESET
RESET
RESET
RESET
RESET
RESET
LEUCHTEN
BLINKEN
1
RESET
RESET
2
RESET
RESET
3
RESET
RESET
4
RESET
RESET
1
2 3
4
collection container 95% full
collection container replacement
recommended, continued operation up to
100% possible.
The buzzer sound can be switched off by
pressing the RESET key. LED 3 remains lit
as a reminder. Buzzer tone sounds again
each time the main switch is switched
on (see 7.2.1. Replacing the collection
container and 7.2.2. Disposing of the
collection container).
LED 1 glows green
LED 3 glows yellow
+ Buzzer tone cannot be
switched off via RESET
RESET
RESET
RESET
RESET
RESET
RESET
LEUCHTEN
BLINKEN
1
RESET
RESET
2
RESET
RESET
3
RESET
RESET
4
RESET
RESET
1
2 3
4
collection container 100% full
Collection container must be replaced.
Further operation is not possible due to the
blocking of the place selection valve (see
7.2.1. Replacing the collection container
and 7.2.2. Disposing of the collection
container).
Centrifuge does not switch
off automatically and is
permanently in operation.
- Error capacitive sensor
Clean sensor
Replace sensor
Notify your service technician.
Centrifuge does not start - Error capacitive sensor
Check sensor connection
Replace sensor
Notify your service technician.
Suctionowisnotreleased - Suctionowvalvedefective
Cleanorreplacesuctionowvalve
Notify your service technician.
Bubbles form in the
container when pump
(module 2) is in operation
-
Reassemble or replace pump housing or
lter
Pumphousingorltermissingor
disassembled
Notify your service technician.
Pump capacity not
sufcient
- Filter for pump missing or disassembled
Reassembleorreplacelter
Notify your service technician.

Other manuals for Metasys COMPACT Dynamic