METER Group, Inc. USA
2365 NE Hopkins Court, Pullman, WA 99163
T +1.509.332.2756 F +1.509.332.5158
E info@metergroup.com W metergroup.com
ATMOS 41 RAIN FUNNEL AND PYRANOMETER REPLACEMENT
Tools Needed
Preparation
Install New Rain Funnel
Update PYR Calibration Factor
Update with a ZSC Bluetooth® Sensor Interface
Update with a ZL6 or EM60 Data Logger
Update with a PROCHECK Handheld Reader
Update with a Campbell Scientific Data Logger
Verify Rain Funnel Installation
Customer Support
Use the following instructions to install a replacement funnel and pyronometer for the ATMOS 41 All-in-One Weather
Station. Please contact Customer Support to order the ATMOS 41 funnel with pyranometer solar sensor.
TOOLS NEEDED
Data logger or
handheld reader
METER ZSC, ZL6, EM60, PROCHECK, Campbell Scientific, Inc. (CSI)
Must be capable of issuing SDI-12 extended commands
Cable
Micro-USB
USB-to-RS232
NOTE: ZSC does not require cables.
Connect from laptop to ZL6 or EM60
Connect from laptop to PROCHECK or CSI data logger
Software USB cable adapter driver (if applicable)
METER ZSC
METER ZL6, or EM60
METER PROCHECK
CSI data logger
ZENTRA Utility Mobile
ZENTRA Utility software
TeraTerm software
LoggerNet software
Sharp-pointed object Use to push tabs in when disconnecting pyranometer connector (e.g., ball-point pen)
Rain funnel (PN 20269) Has the new pyranometer (PYR) solar sensor installed
NOTE: Part number 20269 is for the rain funnel model with waterproof connector and strain relief cable
(serial number newer than ATM-410002462). If an older model is needed, please request the older style
from Customer Support.
PREPARATION
1. Download the software needed to connect the ATMOS41 with the new rain funnel to a laptop or smart device
(phone, tablet).
2. Carefully read this document all the way through.
Figure1 shows an image of the new model with waterproof connector and cable strain relief and the old model.
18339-00
4.10.2020
To Next Page
Need help?
General
