Need help?Do you have a question about the Meterk S1M-GW20-115 and is the answer not in the manual?
General| Power Source | Corded Electric |
|---|---|
| No Load Speed (RPM) | 11000 RPM |
| Frequency | 60Hz |
| Disc Diameter | 4.5 inches |
| Cable Length | 6.56 feet |
| Weight | 4.4 lbs |
Keep work area clean, avoid explosive atmospheres, and keep bystanders away.
Ensures proper plug matching, avoiding earthed surfaces, wet conditions, and cord abuse.
Stay alert, use PPE, prevent unintentional starting, and dress properly.
Proper usage, maintenance, and storage of power tools to prevent accidents.
Warnings for specific operations like grinding, sanding, wire brushing, and abrasive cutting.
Explains kickback and provides precautions to avoid it.
Specific safety advice for grinding and cutting operations.
Emphasizes wearing safety goggles and using detectors for utility lines.
General importance note to read instructions and symbols for safer operation.
Reminder to wear safety goggles for eye protection.
Recommendation to wear ear protection against noise.
Advise to use good quality, strong gloves for hand protection.
Proper disposal of end-of-life electrical equipment.
Feature for locking the spindle during wheel changes.
The main switch for operating the tool.
The secondary handle for better control.
Safety guard for protecting the operator.
Tool for tightening/loosening flange nuts.
Specification for a grinding wheel.
Specification for a cutting wheel.
Instructions on how to attach the additional handle.
Guidance on adjusting the protective guard for safety.
Procedure for a test run of new wheels before use.
How to operate the safety switch to turn the tool on and off.
Step-by-step guide for replacing grinding or cutting wheels.
Details on correct flange configurations for different wheel types.
Importance of keeping motor ventilation holes clean for proper operation.
Guidelines for selecting and using grinding or cutting wheels safely.
Explains different modes of operation, starting with rough grinding.
Technique for achieving best results during rough grinding.
Instructions for cleaning the tool's exterior, vents, and housing.
Guidance on checking carbon brushes by a qualified electrician.
States there are no internal parts requiring additional maintenance.
To Next Page