Metra Electronics 99-7414 User Manual

Disconnect the negative battery terminal to prevent an accidental short circuit. Open the
storage compartment, pull out on the lip of the compartment opening and remove the storage
compartment/trim bezel assembly. Grasp the back of the pocket trim bezel, pull out on the
bezel and remove. Remove (4) screws securing the sub-dash bracket assembly and remove
the assembly. Remove (2) screws securing the bottom of the climate control trim bezel and
(4) screws securing the head unit to the sub-dash bracket assembly. Unsnap the climate
control trim bezel from the head unit and head unit trim bezel.
Slide the aftermarket head unit into the sub-dash
bracket assembly and mount the head unit with
(4) screws supplied with the head unit.
Locate the (4) mounting positions for the sub-dash
bracket assembly ("A").
1
2
5
1
2
ALL VEHICLES
6
4
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Mount the sub-dash bracket assembly to the sub-dash with (4) screws previously removed in
step #1. Mount the Radio Housing/climate control trim bezel assembly over the mounted sub-
dash bracket assembly with (2) screws previously removed in step #1.
Snap the tabs on the top of the climate
control trim bezel into the slots on the
bottom of the Radio Housing.
3
"A"

Metra Electronics 99-7414 Specifications

General

ISO DDIN radio provision	Yes
Wiring Harness	Not included
Antenna Adapter	Not included
Color	Black
Material	Plastic
Brand	Metra Electronics
Part Number	99-7414
Dash Kit Type	Double DIN
Finish	Black
Installation Type	Dash Kit
Function	Radio installation

Summary

Vehicle Installation Procedure

Initial Disassembly and Removal

Disconnect battery, remove storage compartment, pocket trim bezel, sub-dash bracket, and climate control trim bezel.

Head Unit and Trim Mounting

Slide aftermarket head unit into bracket, mount head unit, and snap climate control trim bezel.

Wiring Preparation and Connection

Prepare wiring by stripping ends, twisting together, soldering, and taping, then connect to factory harness.

Final Bracket and Housing Assembly

Mount the sub-dash bracket and the radio housing/climate control trim bezel assembly.

Kit Features Overview

ISO-DIN Head Unit Provisions

Details on the kit's provisions for installing ISO-DIN size head units.

Factory Pocket Retention

Information regarding the retention of the factory pocket within the kit.

Kit Components

Radio Housing Component

Identification and description of the Radio Housing included in the kit.

Tools Required

Phillips Screwdriver

Specifies the Phillips screwdriver as a necessary tool for installation.

Applications

Nissan Sentra 2000-02 Compatibility

Lists the specific vehicle applications for this installation kit, focusing on Nissan Sentra models.