Metra Electronics TYTO-01 - Connections to be Made; 10-pin Harness Connections; 12-pin Harness Connections

From the 10-pin harness:
• Connect the Blue/White wire to the amp turn on wire of the aftermarket radio.
• Connect the White RCA to the left front RCA output of the aftermarket radio.
• Connect the Gray RCA to the right front RCA output of the aftermarket radio.
• Connect the Green RCA to the left rear RCA output of the aftermarket radio.
• Connect the Purple RCA to the right rear RCA output of the aftermarket radio.
3
Connections to be made
TYTO-01
From the 12-pin harness:
• Connect the Yellow wire to the constant 12 volt/battery wire of the aftermarket radio.
• Connect the Red wire to the accessory/switched wire of the aftermarket radio.
• Connect the Black wire to the ground wire of the aftermarket radio.
Online-store car audio and autogoods Winauto
winauto.ua