5
TYTO-01
When using the TYTO-01 with radios that have a really high pre-out voltage or a really low
pre-out voltage, some adjustments may be needed.
If adjustment is needed follow these steps:
1. Find the potentiometer at the 12-pin harness end of the TYTO-01 interface.
2. With the radio at a moderate volume, use a small screwdriver and turn the potentiometer
clockwise to raise the input signal or counterclockwise to lower the input signal.
Audio Level Control
Potentiometer
Online-store car audio and autogoods Winauto
winauto.ua
To Next Page
Loading...
