Metz Connect E-DAT Series

To Next Page

899436

E-DAT kompakte Patchfelder

E-DAT compact Patch Panels

Montagehinweis / Mounting information

E-DAT C6 24x8(8) 1HE LSA Cat.6 Patchfeld Class E

Link 500 MHz

E-DAT C6 24x8(8) 1RU LSA Cat.6 Patch Panel Class E

Link 500 MHz

130855-E

E-DAT C6

24 Port 1HE LSA Cat.6

Patchfeld

E-DAT C6

24 Port 1RU LSA Cat.6

Patch Panel

130855C-E

Öffnen der Geräteabdeckung

Opening of the Panel Cover

Endmontage

Final assembly

Wichtiger Hinweis (für Betrieb und

Abnahmemessung)

Geräteabdeckung muss aufgesetzt sein, wenn Gerät

in Betrieb ist oder die Abnahmemessung durchgeführt

werden soll.

Important Note (for Operation and Acceptance

Measurement)

The panel cover has to be put on for operation and the

acceptance measurement.

Geräteabdeckung am Patchfeldrahmen ansetzen Ê und nach

unten einrasten Ë.

Apply the cover to the patch panel frame Ê and click it down-

wards into place Ë.

Anschluss des Potentialausgleichs

Fit the earthing lead

Rasthaken leicht eindrücken Ê und die Geräteab deckung

nach oben klappen Ë.

Slightly push-in the snap-fits Ê and turn the cover up Ë.

METZ CONNECT GmbH | Im Tal 2 | 78176 Blumberg | Germany

Tel. +49 7702 533-0 | Fax +49 7702 533-433

Weitere Dokumentationen siehe / Further documentation see www.metz-connect.com

E-DAT design 24x8 Patchfeld Class E / Cat.6 Link bis 250MHz

E-DAT design 24x8 Patch Panel Class E / Cat.6 Link bis 250 MHz

130853-E

Need help?

Do you have a question about the Metz Connect E-DAT Series and is the answer not in the manual?

Summary

E-DAT Compact Patch Panels

Mounting Information

Provides mounting instructions for E-DAT compact patch panels, including product variants and specifications.

Final Assembly Instructions

Opening the Panel Cover

Steps to open the device cover for access, involving pushing snap-fits and lifting.

Important Note for Operation and Measurement

Ensures the panel cover must be on for operation and acceptance measurements.

Earthing Connection

Instructions for fitting the earthing lead to the patch panel frame.

Cable Preparation and Connection

Cable Preparation Steps

Detailed steps for preparing the cable, including sheath stripping, shield management, and wire pair separation.

Pin Assignments

Reference table for T568A and T568B wiring standards for connector pins.

Cable Connection Procedure

Instructions on connecting cables to ports, managing wire pairs and shield foil up to the contacts.

Strain Relief and Shield Clamp

Guidance on creating strain relief with cable ties and attaching the shield connection clamp.