Need help?Do you have a question about the Metz SCA 3202-M7 and is the answer not in the manual?
Details the front and rear views of the SCA adapter, including switch and sensor locations.
Provides step-by-step instructions for attaching the SCA adapter to mecablitz units and cameras.
Explains how the camera sets shutter speed/aperture for balanced exposure and TTL flash control.
Details setting shutter speed, with the camera automatically selecting aperture for ambient light.
Explains setting aperture, with the camera automatically adjusting shutter speed for ambient light.
Describes setting both aperture and shutter speed manually in "M" mode for full control.
Explains TTL mode where camera sensor meters flash exposure via preflashes for automatic control.
Describes Auto mode where flash unit sensor controls light output for correct exposure.
Explains Manual mode where full or partial light output is used without sensor control.
Details how the camera merges ambient and flash light for fill-in or main light in Program mode.
Explains the flash ready symbol and its meaning for correct firing.
Describes how shutter speed automatically adjusts to flash sync speed based on camera type and mode.
Explains the "OK" confirmation for correct exposure in TTL and Auto modes.
Details how the reflector's coverage angle automatically adapts to the camera lens focal length.
Explains the AF beam activation for focusing in low light conditions.
Describes how the flash unit indicates maximum flash range based on transmitted camera data.
Explains the preflash function to reduce red-eye by narrowing pupils before the main flash.
Flash triggered at the beginning of exposure (1st curtain sync), the standard mode.
Flash triggered at the end of exposure (2nd curtain sync) for motion blur effects.
Combines slow shutter speeds with flash for background illumination in low light.
Allows flash operation with shorter shutter speeds than standard sync speed.
Explains how the SCA adapter wakes up the flash unit from standby when the shutter release is touched.
Details flash units that act as controllers in Metz Remote Flash Mode.
Describes flash units operating as slaves controlled wirelessly by a master unit.
Explains triggering the slave flash unit by the camera's built-in flash light pulse.
Provides instructions for setting the SCA adapter switch to "SL" (SLAVE) mode.
Details setting the flash unit and camera for slave operation, including ISO and aperture.
General| Brand | Metz |
|---|---|
| Model | SCA 3202-M7 |
| Category | Camera Accessories |
| Language | English |
To Next Page
