Need help?Do you have a question about the METZGER T164-10A and is the answer not in the manual?
Settings for limit control (max 200°F) and blower control (e.g., 120°F ON).
Adjusting blower speed for 70°-100°F air temperature rise.
Steps for starting the burner and initial adjustments for flame.
Using instruments for draft, smoke, CO2, and flue gas temperature.
Basic checks: voltage, thermostat, oil supply, and required instruments.
Troubleshooting for burner motor not starting or short cycling.
Checks for achieving clean combustion via air adjustments.
Troubleshooting for blower not starting or cycling improperly.
Electrical wiring diagram for T165 Series Oil Furnace Belt Drive.
Electrical wiring diagram for T165 Series Oil Furnace Direct Drive.
To Next Page
General