9
light indicates the
snow plow is now in
the Lower/Float posi-
tion. In this position
the snow plow will
be able to follow the
contour of the road
and the snow plow
can also be angled
to the left or right.
Touching the up
arrow automatically
cancels the Lower/
Float position.
While angling left or
right or raising the
snow plow if the button is pressed for more than four seconds the
operation will be cancelled. This feature eliminates unnecessary amp
draw from the vehicle charging system.
This switch is self diagnosing. The monitor light is located in the upper
left corner next to the float light of the control switch. When the moni-
tor light turns on and begins to flash the control switch is sensing a
problem with a specific coil/connection on the hydraulic unit. The label
below is on the back side of your control switch.
Reset is accomplished by turning off the ignition switch or by turning
the power switch off momentarily and then back on. If the monitor
light is still illuminated after attempts to reset the switch have failed,
contact your nearest authorized Meyer Distributor for repairs.
22690
Pistol Grip Controller
To Next Page
Loading...
