7
ADJUSTING CHAIN FOR PROPER SLACK WHEN
PLOWING SNOW
1. Be sure lift piston is fully retracted.
2. Hold chain taut and choose the third link above lift
arm, place that link in lift arm locking groove. This
procedure will provide the proper amount of slack
when snow plowing for the moldboard to follow
the contour of the ground. You may wish
to mark that link with paint or tape for easy
identification. Due to the differences in
vehicle ride heights, extra chain links may
vary in length. To prevent the extra chain
links from causing damage, remove or
secure the chain links together using an
electrical tie strap.
™
To Next Page
Loading...
