Continue programming by pressing Play (Pause) or REC to add a second
hi-hat.
Now, turn the Value control again to create a closed hi-hat by setting a
short value for the note length (example).
Subsequently, program the rest of the pattern.
Complete the procedure by pressing the corresponding instrument button.
Hint: You only need to turn the Value control in case you want to change the
parameter value for this step.
CL and BO are programmed by first pressing REC followed by a double click on
CP/CL respectively TT/BO. Next, release both buttons. For example: (REC +
CP/CL + CP/CL).
Pattern Length
In case you want a pattern with less than 16 steps, end programming at any time
by pressing the corresponding instrument button. The last programmed track sets
the overall pattern length.
Example:
BD-track, press REC once, 5 x Play, REC once, 5 x Play and finally BD to
complete programming. As a result, you did program 12 steps, equaling a 3/4 bar.
Real Time Mode
Start the sequencer and press REC (You will hear the clave sound CL in a 4/4
beat). You can now set the steps in real time by pressing the corresponding
instrument buttons or by using MIDI (see MIDI implementation list). By pressing
and holding the instrument button, the track will be deleted.
Use the Value control to change the pitch, length or the extras for the instrument
that was programmed last.
Programming of CL and BO is possible by pressing REC twice. In explanation: 1
x REC = CP and TT, once more REC = CL and BO. Pressing REC again will
end the recording.
The level of the instruments can be changed per pattern. Press Play followed by
the Value control's push function until the left LED is lit. Press the instrument
button afterwards, e.g. BD. Use the Value control to adjust the level of the BD
track. CL and BO can be adjusted with the red LED being lit. (Press Value
twice). The headphones level can be set with both LEDs being lit. Make sure to
directly save the pattern. Else, the settings will be lost when switching the unit
off.
To Next Page
Loading...
