1 1.4 10.0 1.4 5.0 9.9 1.3 1.4
2 1.4 10.0 1.4 5.0 2.5 1.3 1.4
3 0 0 0 5.0 0 0 0
4 3.9 3.3 4.0 0 2.9 4.9 4.7
5 3.9 4.9 4.0 5.0 4.9 4.9 4.7
6 4.9 3.3 5.0 5.0 0 5.7 5.8
7 4.5 0 4.6 5.0 0 4.9 5.2
8 5.0 10.0 5.1 9.9 4.9 4.9 5.8
BIPOLAR AND JFET DEVICES:
D/E = Drain/Emitter
S/B = Source/Base
G/C = Gate/Collector
* = Test in TRANSMIT mode
** = Test with TUNE switch depressed
*** = DO NOT TEST gate of Q9 may cause generation of parasitic oscillations.
Q1 Q2 Q3 Q4 Q5* Q6 Q7* Q8** Q9 Q10
D/E 9.8 0 9.0 9.7 0 0 3.5 0 13.0 0.25
S/B 2.3 0.7 3.9 8.9 0.7 0.7 2.8 0 0 1.0
G/C 0 13.2 0 4.3 13.0 0 0 9.0 *** 13.7
Q11 (MRF477 PA Transistor): To avoid RF damage to DVM, check
collector voltage in receive mode only full supply voltage
(13.8v) should be present. Check base (bias) with PTT pressed,
no audio this should indicate 0.6v. Emitter is grounded.
SCHEMATIC DIAGRAM, MFJ 9420:
PARTS LIST:
To Previous Page