51
3. Insert the charger plug into the charging
port.
Remove the charger plug cap.
Insert the charger plug into the charging port
until you hear a “click”.
Insert the charging gun correctly, and then
the green indicator light flashes.
1) Green light 1 -first green light is for
POWER ON and it will continuously
remains ON while charging
2) Green light 2 (center)- will blink (in green
color) during charging, will remain ON
when SOC reaches 100%.
3) Red light- for malfunctioning During
charging, the green indicator light flashes.
In case of any malfunction, the red
indicator light is always on or flashing.
4) Pull out the charger plug after charging.
Switch off the supply, pull out the charging
gun and fit the charging gun cover, charging
cap and charging port door in place.
Precaution
Do not try to remove the charging gun
when charging is ON. If it is necessary
to interrupt the charging of the vehicle,
isolate the power supply first, then
disconnect the vehicle plug.
Smart Charging
The 12V battery SOC is constantly
monitored, when the Start/Stop switch is
in the OFF position it is possible, under
certain conditions, that the HV battery will
automatically charge the 12V battery to
ensure the vehicle starts. This function will
activate and switch off automatically.
Notes
The system will suspend intelligent
charging if a fault is present, when starting
or the vehicle is being charged by an
external device.
Notes
The driving range will be reduced after
intelligent charging.
Notes
The intelligent charging function is
suspended when the high voltage battery
is in a low SOC.
Driving and Controls
To Next Page
Loading...
