228 229
Complete Vehicle Performance and Main Engine Parameters
STC (4x2) DTC (4x4)
Engine model
Type In-line 4-cylinder, water-cooled, turbocharged, In-line 4-cylinder, water-cooled, turbocharged,
intercooled, direct injection, diesel engine intercooled, direct injection, diesel engine
Displacement, L 1.996 1.996
Number of Cylinder 4 4
Cylinder Bore, mm 83 83
Stroke, mm 92 92
Volume Compression Ratio 15.9:1 15.9:1
Engine speed at rated power, rev/min 4000 4000
Maximum net power, KW 118.5 158.5
Maximum torque, Nm 375 480
Engine speed at maximum torque, 1500~2400 1500~2400
rev/min
Idle speed, rev/min 750±25 750±25
Fuel Type and Grade 0# diesel 0# diesel
Fuel tank capacity, L 75 75
Maximum design speed, km/hour 180 180
Maximum gradability, % 40.4 40.4
Emission level reached when the
BS-VI BS-VI
complete vehicle leaving factory
Front Suspension Structure Double wishbone independent suspension
Rear Suspension Structure Five-link non-independent suspension
Dynamic Balance Requirements of Residual dynamic unbalance allowable at one side: below 10 grams
Steel Wheels Maximum balance block applied at outer side is 60 grams, and the total of two sides shall not
exceed 120 grams
Dynamic Balance Requirements of Residual dynamic unbalance allowable at one side: below 8 grams
Aluminum Wheels Maximum balance block applied at one side is 80 grams, and the total of two sides shall not
exceed 160 grams
Rational Range of Brake Pedal Free
within 10 mm
Stroke
Rational Use Range of Brake Friction Friction material thickness is greater than 2 mm
Chassis Technical Parameters:
Item Parameters
GENERAL TECHNICAL PARAMETERS GENERAL TECHNICAL PARAMETERS
To Next Page
Loading...
