LASER RANGEFINDER
INSTRUCTIONS
Changing Modes
Pressing and releasing black button switches between MG-Lock
Measurement Mode (MD) which locks onto pin, and MG-Lock
Recommended Distance Mode (RD) which locks onto pin & adjusts for
slope.
Vibrating MG-Lock Conrmation Feature
In MG-Lock (Measurement and Recommended Distance) Modes, a
vibrating pulse gives tactile feedback that the rangender has locked on
to the targeted object.
M
Power On & Take
Measurement
Hold red button for
approx 1 sec. (Automatically
shuts o after 1 minute, no manual o.)
Subsequent press and release of red button takes a measurement.
MG-Lock Recommended Distance Mode (Scan RD)
(Slope)
Recommended Distance Mode
(indicated by RD on LCD and
icon) adjusts distance based
on angle of the slope. Aim, then
press and release red button.
Distance and slope angle readings
will alternate in viewnder, both
display simultaneously on side LCD
panel. (This mode also includes MG-
Lock, indicated by icon, which locks onto a target with something
(like a bunker or tree) behind it.
^
^
^
|
Scan
- - -
Y
150 yds.
150 yds. (uphill)
6°
X
Example: Measurement modes (MD and standard) will measure 150
yards for both the level and uphill distances resulting in the uphill shot
falling short by several yards. RD mode will instead adjust the distance
higher on the uphill shot, or lower on a downhill shot,
telling you the distance the shot will play.
(For illustrative purposes only. Not to scale.)
(Continued on Reverse Side)
M
To Next Page
Need help?
General
