Precautions for Use:
MHC Medical Products, LLC is not responsible for any injury resulting
from incorrect use of the EasyTouch
®
Glucose Monitoring System
and not in line with the instructions set forth in this operating manual.
Only use EasyTouch
®
Test Strip with the EasyTouch
®
Meter.
Any change or administer of medication based on the EasyTouch
®
blood
glucose test results without the consent and advice of a physician or
healthcare professional is not recommended.
BEFORE TESTING:
Read detailed instructions in your EasyTouch
®
User’s Manual.
MHC Medical Products, LLC
8695 Seward Road,
Fairfield, Ohio, 45011
1. Press the M button to turn on the Meter.
The date and time will appear rst.
2. Press the S button once and the result of
control solution test will be shown.*
3. Press the S button again to display your
7-day average, twice for 14-day average,
and three times for 30-day average.*
4. Press the S button again and the meter will
recall the last 300 test results in most
recent order taken.*
5. When “000” appears, you have reached the
end of your results.
6. Press the M button to turn o the meter.
*If there is no test results during
this stage, the most recent test
result will directly appear.
Insert a Test Strip, push all the way into test
port until meter automatically turns on. A
beep will sound and moving dotted lines will
appear followed by a ashing " " symbol.
Now you are ready to obtain a blood sample.
Glucose Monitoring System
Easy•Touch
®
Meter detects blood glucose level
higher than 600 mg/dL (33.3 mmol/L).
Meter detects blood glucose level lower
than 20 mg/dL (1.1 mmol/L).
Ambient temperature was too high to
perform the test.
Ambient temperature was too low to
perform the test.
Test strip is not inserted
properly/Defective test strip.
Meter malfunction. Please call
customer service.
Battery power is low. Meter will provide
approximately 50 more measurements.
Battery power is low. Replace
immediately.
Display Messages
To turn the Meter on, rst insert the battery, then press the
reset button located at the back of the Meter and proceed
with the following instructions.
B04Q105098(01)
Rev. date: 09/2011
DH-080411.6
Place blood sample onto the end of the test
strip. The meter will beep when enough
blood has lled the strip, (0.5ul).
After 5 seconds, your blood glucose result will
appear on the display and will automatically
be stored into the Meter’s memory.
STEP 1
STEP 2
STEP 3
Test Summary
Memory Feature
Questions or Comments?
Call 877.358.4342
www.EasyTouchProducts.com
To Next Page
Need help?
General
